Table of Contents
Advertisement
You can return the display to its factory default conditions whenever you wish. If you do so,
you will permanently loose all your settings and will need to start from the beginning again.
The calibration Audit Counter will NOT be reset, there is no way provided to reset this value,
as it is intended as a secure record to indicate whether changes have been made to the
display since it was last calibrated..
This feature is available in Easy and Advanced Modes
Set1
1
Digit
Press together for 3 seconds
Set1
Digit
2
Set1
Digit
3
Your display includes a non-resettable counter which increments each time you make a
change to the display's calibration. This is useful if you want to check whether a display has
been altered since it was last calibrated.
The Calibration audit number starts at
to be recorded. Whenever you want to check the calibration audit number, press and hold
the 2 outer buttons (Set1 + Alarms) for more than 3 seconds.
Set1
Digit
1
Press together for 3 seconds
Set2
Output
Alarms
OK
Max/Min
Reset
Set2
Output
Alarms
OK
Max/Min
Reset
Set2
Output
Alarms
OK
Max/Min
Reset
Press to accept
CAL 01
Set2
Output
Alarms
OK
Max/Min
Reset
Factory Defaults
Lockout Switch must be OFF
Display shows :-
defs n
(Defaults no)
Press the DOWN button to change the
display to
defs y
want to return to default conditions.
Calibration audit number
up to
CAL FF
allowing up to 255 alterations
OFF
Circuit board
ON
(Defaults Yes) if you
Done!
Done!
29
Advertisement
Table of Contents
