Hang Mount Bracket Installation; Component Installation; Installation; Installation Requirements - Dahua DH-SD60230U-HNI Installation Manual

4 HANG MOUNT BRACKET INSTALLATION

4.1 Component Installation

Hang mount bracket and its components are shown as below. See Figure 4-1.

4.2 Installation

4.2.1 Installation Requirements

The hang mount speed dome can be installed in the hard construction wall in the indoor or
outdoor environments. Before the installation, please make sure:

The wall is thick enough to install the expansion bolt.

The wall can at least sustain the 8x weight of the speed dome.

4.2.2 Installation Steps

Step 1
Loosen the M4 bolt in the connection plate to separate the connection plate and connection pole.
Pull the integration cable through the airproof slot of the bottom of the connection plate and then
connect to the centre hole of the flange. Please secure the connection plate in the ceiling. See
Figure 4-2.
Figure 4-1
19