Changing The Predefi Ned Parameters Set - FAAC B680 Manual

Display Function
S1 Loop 1 sensitivity
Adjusts the sensitivity of the vehicle detection
loop
00
Minimum sensitivity
10
Maximum sensitivity
S2 Loop 2 sensitivity
Adjusts the sensitivity of the vehicle detection
loop
00
Minimum sensitivity
10
Maximum sensitivity
Mt Motor movement
Using the function provided by this para-
meter makes it possible to manually move
the barrier bar, operating as dead-man.
Pressing + will open the automated system,
pressing - causes the automated system to
close.
oP
pressing +, open
cL
pressing -, close
tL Learning
Working time and limit switch learning (see
section 7.2)
St AUTOMATED SYSTEM STATUS:
This allows you to choose whether to quit the programme
and save the data.
Y
= quit and save the data
no
= quit without saving the data
On quitting the programme, press the F key to display
the status of the automated system
00
Beam closed
01
Beam open
02
Stationary ready to open
03
Stationary ready to close
04
Automated system paused
05
Opening
06
Closing
07
Failsafe in progress
08
2-EASY device verification in progress
09
Pre-flashing then OPENS
10
Pre-flashing then CLOSES
11
EMERGENCY Open
You can go to St at any time by simultaneously
pressing F and -.
Displaying of the automated system status
important for the installing/maintenance technician in order
to distinguish the logical processes that the board carries
out during movement.
If, for example, the automated system status is CLOSED,
the display MUST read
received, the display will change to
enabled, or directly to
01
then display once the position of gate OPEN is reached).
Default
05
05
--
--
St
is extremely
00
. When the OPEN command is
09
, if pre-fl ashing is
05
(the OPENING movement) to
Example of a status sequence displayed starting from a closed barrier
The sequence does not include statuses
correspond to pre-flashing when opening and closing,
respectively.
5.2 Changing the predefi ned parameters set
The E680 board features six sets of pre-defined configurations that
allow rapid adapting to the size of the beam installed, making it the
starting point for a fine adjustment of the parameters. To select one of
the available configurations, it is necessary to change the parameter
cF
from the default value of
configuration (beam length, type and quantity of accessories installed)
given in Table 4 or Table 5 on page 25 (for example, choose the default
04
for a beam L of 5 metres with lights and foot).
00
Beam closed
01
Beam open /
04
Pause
To complete configuration, it is necessary to exit the Basic
Configuration menu by pressing "F" until parameter
or by pressing "F" and "-"
This operation changes the value of the parameters
So SC
and in Basic confi guration and
in Advanced confi guration, setting them on the default
values as shown in the tables in paragraph 6.3.
Unlike the other parameters, the value of step
thus allowing access to the menu through a neutral condition,
which is the one displayed every time the configuration
menu is opened..
If you do not wish to load any set of pre-defined parameters, leave
St 00
parameter on and press "F" to go on to the next parameter
Setting a set of pre-defi ned parameters that does not
correspond to the actual confi guration of the barrier could
cause irreversible damage to the automated system, in
particular if the default corresponds to a beam length
shorter than the actual one.
10
09 10
and
06
to that corresponding to the barrier
05
Opening
06
Closing
St
is reached
FO
,
dF
is not stored,
which
FC oc
,