Table of Contents
Advertisement
1-1) Machine
mobilization
Danger
1-2) Machine
Installation
Caution
1-3) Troubleshooting
Danger
Only personnel with a full understanding of the safety rules should move the
machine. The following directions must be observed when transferring the machine.
ⓐ At least 2 persons should move the machine together.
ⓑ In case the machine should be transported, wipe the oil covered on the machine to
prevent accidents.
Because physical damages such as the machine' s dysfunction and breakdown are
likely to occur depending on the environment in which the machine is installed, the
following preconditions must be met.
ⓐ Please unpack the machine package in order. Be particularly careful of the nails in the
wooden box.
ⓑ Because machines are apt to be contaminated and corroded by dust and moisture,
install a climate controller and clean the machines regularly.
ⓒ Keep the machine out of direct rays of the sun.
ⓓ Keep both sides and the backside of the machines at least 50cm from the wall to secure
enough space for repair.
ⓔ Danger of Explosion
Don' t run the machine near places with any danger of explosion.
Don' t run the machine near places with any danger of explosion, including places
where sprays like aerosol are used in large quantities or oxygen are dealt with, unless
the exact actions concerning the operation are guaranteed to avoid the explosion.
ⓕ Illuminators do not come equipped with the machine due to the machine's characteristics.
So, users should install the lighting apparatus around the working area.
[Note] The details about the installment of the machine are described in No. 2
Installations.
If in need of troubleshooting, call a trained A/S engineer who has been educated by
Sunstar.
ⓐ Be sure to turn the power off before cleaning and repair. And wait for about 4 minutes
until the machine discharges completely.
ⓑ Part of or the entire machine should not be modified without any consultation with our
company
ⓒ In case of repair, change the damaged part into the genuine part of our company
ⓓ After repair, cover the machine with the safety cover that was removed for repair.
5
Advertisement
Table of Contents
