Pen Holder - HP Pavilion TX1000Z Maintenance And Service Manual

Pen holder

Description
Pen holder
Pen eject assembly
Before removing the pen holder, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power cord.
3.
Remove the battery (see
4.
Remove the following components:
5.
Pen (see
a.
Hard drive (see
b.
Memory module compartment cover (see
c.
Optical drive (see
d.
Keyboard (see
e.
Switch cover (see
f.
Display assembly (see
g.
Top cover (see
h.
Power switch assembly (see
i.
System board (see
j.
Remove the pen holder:
Remove the Phillips PM2.0×5.0 screw (1) that secures the pen eject assembly to the base enclosure.
1.
Remove the pen eject assembly (2).
2.
Remove the two Phillips PM2.0×5.0 screws (3) that secure the pen holder to the base enclosure.
3.
68 Chapter 5 Removal and replacement procedures
Battery on page
Pen on page 37)
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
Display assembly on page
Top cover on page
Power switch assembly on page
System board on page
36).
38)
Memory module on page
42)
47)
50)
52)
59)
66).
Spare part number
441146-001
441145-001
43)
63)
ENWW