HP Pavilion TX1000Z Maintenance And Service Manual page 58

Remove the WLAN module compartment cover and disconnect the wireless antenna cables from the
7.
WLAN module (see
Remove the following components:.
8.
Keyboard (see
a.
Switch cover (see
b.
Remove the display assembly:
Close the computer and turn it upside down, with the front toward you.
1.
Loosen the Phillips PM2.0×4.0 screw (1) that secures the display connector cover to the computer.
2.
Lift the rear edge of the display connector cover (2) and swing it toward you.
3.
Remove the display connector cover.
4.
NOTE:
441138-001.
Remove the two Phillips PM2.5×6.0 screws (3) that secure the display assembly to the computer.
5.
Remove the WWAN antenna cable (1) from the routing channel built into the base enclosure.
6.
ENWW
WLAN module on page
Keyboard on page
Switch cover on page
The display connector cover is included in the Plastics Kit, spare part number
44).
47)
50)
Component replacement procedures 53