System Board - HP Pavilion TX1000Z Maintenance And Service Manual

System board

Description
For use only with computer models equipped with WWAN
For use only with computer models not equipped with WWAN
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
Memory module (see
●
● WLAN module (see
RTC battery (see
●
Bluetooth module (see
●
Fan/heat sink assembly (see
●
Processor (see
●
Before removing the system board, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power cord.
3.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Memory module compartment cover (see
b.
Optical drive (see
c.
Keyboard (see
d.
Switch cover (see
e.
Display assembly (see
f.
Top cover (see
g.
Power switch assembly (see
h.
Remove the system board:
Disconnect the ZIF connector (1) to which the audio/infrared board cable is attached and disconnect
1.
the audio/infrared board cable (2) from the system board.
Press in on the ExpressCard slot bezel (3) to release the bezel from the ExpressCard slot.
2.
66 Chapter 5 Removal and replacement procedures
Memory module on page
WLAN module on page
RTC battery on page
Bluetooth module on page
Fan/heat sink assembly on page
Processor on page 74)
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
Display assembly on page
Top cover on page
Power switch assembly on page
43)
44)
62)
65)
36).
38)
Memory module on page
42)
47)
50)
52)
59)
Spare part number
441097-001
441096-001
71)
43)
63)
ENWW