Pen Holder And Eject Assembly - HP TOUCHSMART TM2 Maintenance And Service Manual

Pen holder and eject assembly

Description
Pen holder and eject assembly
Before removing the pen holder and eject assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Memory cover (see
c. Top cover (see
Remove the pen holder and eject assembly:
1. Remove the three Phillips PM2.0×4.0 screws (1) that secure the pen holder and eject assembly to
the base enclosure.
2. Remove the pen holder (2) and eject assembly (3) from the base enclosure.
Reverse this procedure to install the pen holder and eject assembly.
52 Chapter 4 Removal and replacement procedures
Battery on page 35).
Hard drive on page 37).
Memory module on page
Top cover on page 48).
40).
Spare part number
592972-001
ENWW