Pen Holder And Pen Eject Assembly - HP PAVILION TX2500 Maintenance And Service Manual

Pen holder and pen eject assembly

Description
Pen holder and pen eject assembly
Before removing the pen holder and pen eject assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
5. Remove the following components:
a. Pen (see
b. Hard drive (see
c. Memory module compartment cover (see
d. Optical drive (see
e. Keyboard (see
f. Switch cover (see
g. Display assembly (see
h. Top cover (see
i. Power switch assembly (see
j. System board (see
Remove the pen holderand pen eject assembly:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the pen eject assembly to the base
enclosure.
2. Remove the pen eject assembly (2).
3. Remove the two Phillips PM2.0×3.0 screws (3) that secure the pen holder to the base enclosure.
Battery on page
Pen on page 40)
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
Display assembly on page
Top cover on page
Power switch assembly on page
System board on page
39).
41)
Memory module on page
43)
49)
51)
53)
56)
62)
Component replacement procedures
Spare part number
464113-001
44)
59)
65