Table of Contents
Advertisement
E. Install Decorative Barrier Front
WARNING! Risk of Fire! Install ONLY decorative barrier
fronts approved by Hearth & Home Technologies. Unap-
proved decorative barrier fronts could cause fireplace to
overheat.
WARNING! Risk of Fire! A decorative barrier front is re-
quired for this model. DO NOT operate the fireplace with
the barrier front removed.
IMPORTANT! This fireplace requires an installed
decorative barrier front to prevent direct contact with
the hot viewing glass.
The decorative barrier front included with this model is the
only one certified for use with this appliance. No other
decorative barrier fronts may be used.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one
1. Remove the decorative barrier front from the appli-
ance.
2. Remove cardboard wrap and protective bag from
decorative barrier front.
3. Bend the front hanging brackets to separate from the
assembly. See Figure 11.3 and Figure 11.4.
4. Locate the mounting tabs on the two hanging brack-
ets. The mounting tabs are shipped unbent. Use a
pliers to bend the tabs to 90 degrees as shown in
Figure 11.4.
5. Install the left hanging bracket by positioning the
arrows upward and outward. Install a hex screw in
each mounting hole. See Figure 11.5.
right auxiliary hanging bracket.
FRONT HANGING BRACKETS
ATTACHED TO DECORATIVE
BARRIER FRONT FOR SHIPMENT
Figure 11.3 Decorative Barrier Front Assembly Shown as Shipped
Hearth & Home Technologies • DVLINEAR36 Installation Manual • 2569-980 Rev. E • 11/20
60
6. Install the decorative barrier front assembly by hanging
it from the four tabs located on the auxiliary brackets.
There are two tabs on the left side and two tabs on the
right side. See Figure 11.6.
Figure 11.4 Preparation of Mounting Brackets
Repeat for
(LEFT BRACKET)
Figure 11.5 Install Hanging Brackets
LEFT
ARROW MUST POINT UP
WHEN INSTALLED
ARROW MUST POINT OUT
(AWAY FROM FIREBOX)
WHEN INSTALLED
MOUNTING TABS
BENT TO 90 DEGREES
(TOP & BOTTOM)
(RIGHT BRACKET)
RIGHT
MOUNTING
HOLES
Advertisement
Table of Contents
