Intellifire™ Touch Control System Setup; Led's; Install Decorative Barrier Front - Majestic MARQ36IN-B Installation Manual

I. IntelliFire™ Touch Control System Setup
• Detailed instructions for electrical wiring and connec-
tions are provided in Section 8.
• Verify that the 3-Position switch on the IFT-ECM is
switched to the REMOTE position. Detailed Operat-
ing Instructions for the IFT-ECM are provided in Sec-
tion 3.J of the Owner's Manual.
3 POSITION SWITCH
LED INDICATOR
Figure 11.5 IFT-ECM
This appliance is factory-equipped with an IntelliFire™
Touch remote control. The remote was paired to the fire-
place and tested at the factory. It does not need to be
paired again, unless an accessory kit will be added at
the time of installation. If no additional accessory will be
added, simply follow steps one through seven below.
1. If installed, remove batteries from remote.
2. Verify that the new appliance has power and secure
electrical connections.
3. Adjust the ECM selector switch to 'REMOTE' mode.
4. Wait to verify LED indicator on the ECM stops flash-
ing.
5. Install batteries in the RC400 remote.
6. The RC400 remote will automatically pair to the appli-
ance as pre-set at the factory.
TOP VIEW
Majestic MARQ36IN-B, MARQ42IN-B Installation Manual • 2614-980 Rev. D • 4/19
J. LED's
LED's are factory installed. No additional set up or acti-
vation required.
• See Owner's Manual for maintenance and bulb
replacement.
K. Install Decorative Barrier Front
WARNING! Risk of Fire! Install ONLY decorative barrier
fronts approved by Hearth & Home Technologies. Unap-
proved decorative barrier fronts may cause fireplace to
overheat.
This fireplace has been supplied with an integral
barrier to prevent direct contact with the fixed glass
panel. DO NOT operate the fireplace with the barrier
removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
For more information refer to the instructions supplied with
your decorative barrier front.
63