Table of Contents
Advertisement
Alternate and Supplemental Installation Instructions
The below instructions may be referenced for scenarios in which the standard installation
procedures cannot be followed.
Install Rear Louver Panel / Grille Directly on Back of Air Conditioner
If your installation scenario does not allow you to attach the Rear Louver Panel / Grille to the
Wall Sleeve you may carefully secure the Panel directly to the rear of the Air Conditioner unit.
1. Attach the 1" x
2. Position the Grille over the rear of the air conditioner ensuring that:
-
The double set of screw holes are on the bottom.
-
The Grille fins are pointed away from the unit.
3. Align the top of the Grille with the top of the air conditioner unit.
-
Holes should be pre-drilled, but if required, carefully pre-drill 4 (four)
the Grille and into the side flange of the air conditioner cabinet frame approximately
1 ½" – 2" from the top and bottom.
4. Attach the Grille to the unit with 4 (four) self-tapping screws.
5. Install the unit into the sleeve.
Non-Koldfront Wall Sleeve Types
The below diagrams may be used as a reference when installing your Koldfront Through The
Wall Air Conditioner into a non-Koldfront branded Wall Sleeve. Regardless of brand, please
ensure that your wall sleeve is securely installed into the wall opening and is properly sealed.
Additionally, as noted previously, please ensure that your air conditioner is installed with a
slight rearward tilt to allow for proper drainage.
11
" x 14" seal pieces.
3
/
8
" holes through
1
/
8
Advertisement
Table of Contents
