Installing Ide And Scsi Support; To Install Ide Support - HP OmniBook 2000 Evaluator Manual
Hp omnibook 2000: user guide
Hide thumbs
Also See for OmniBook 2000:
- User manual (69 pages) ,
- Service manual (119 pages) ,
- Installation and setup manual (101 pages)
Table of Contents
Advertisement
Installing IDE and SCSI Support
These procedures are necessary only for OmniBooks that have been loaded with a
retail version of Windows 95A.
Requirements
To install IDE support
1. From Control Panel, double-click System, then click Device Manager.
2. Double-click Hard Disk Controllers, and remove the Opti Dual PCI IDE
3. Click No, Do Not Restart The OmniBook.
4. Close Device Manager, then close Control Panel.
5. From the Start menu, click Shut Down, then click Yes.
6. Press the Off button on the left side of the OmniBook, then press the blue
Important
You must reset the OmniBook in order to successfully install IDE support.
6. Windows detects new hardware and prompts you to restart the OmniBook.
OmniBook 2000/5700 with Windows 95 installed.
OmniBook 2000/5700 driver for SCSI support.
Location: OmniBook hard drive or Recovery CD in
\OMNIBOOK\DRIVERS\WIN95\950AONLY.
Controller.
On/Suspend button to restart the OmniBook.
Click Yes to restart.
Using Windows 95
Installing IDE and SCSI Support
3-9
Advertisement
Table of Contents
