Mass Storage Device - HP Envy 13-1030 Maintenance And Service Manual

Mass storage device

✎
The mass storage spare part kit includes a rubber isolator.
Description
Hard drive:
■ 250-GB, 5400-rpm hard drive
■ 160-GB, 5400-rpm hard drive
■ 120-GB, 5400-rpm hard drive
160-GB solid-state drive
Before removing the mass storage device, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the top cover (see
6. Remove the mass storage device bracket (see
Remove the mass storage device:
1. Release the mass storage device 1 by lifting it as far as the mass storage device cable allows.
2. Disconnect the mass storage device cable 2 from the mass storage device.
3. Remove the mass storage device.
Reverse this procedure to install the mass storage device.
Maintenance and Service Guide
"Battery" on page 4-7).
"Top cover" on page 4-8).
"Speaker assembly" on page
Removal and replacement procedures
Spare part number
538327-001
538326-001
538325-001
538329-001
4-13).
4–15