Digital Media Slot Board - HP Envy 13-1030 Maintenance And Service Manual

Removal and replacement procedures

Digital Media Slot board

Description
Digital Media Slot board (includes cable)
Before removing the Digital Media Slot board, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the top cover (see
Remove the Digital Media Slot board:
1. Disconnect the Digital Media Slot board cable 1 from the system board.
2. Remove the Digital Media Slot board cable from the clip 2 built into the power connector bracket.
3. Remove the three Phillips PM2.0×4.0 screws 3 that secure the Digital Media Slot board to the base enclosure.
4. Release the Digital Media Slot board by lifting the front edge 4 of the board until it rests at an angle.
5. Remove the Digital Media Slot board 5 by sliding it away from the computer at an angle.
Reverse this procedure to install the Digital Media Slot board.
4–12
"Battery" on page 4-7).
"Top cover" on page 4-8).
Spare part number
538337-001
Maintenance and Service Guide