Compaq tc1000 Maintenance And Service Manual page 128

Removal and Replacement Procedures
✎
Make sure the docking stand and pivot arm are supported before
removing the following screws. The docking stand and pivot arm
can fall if not supported.
7. Remove the following screws:
❏
❏
❏
8. Remove the docking stand and pivot arm
Figure 5-33. Removing the Docking Stand and Pivot Arm
5–40
Two PM2.5 × 5.0 screws
to the bottom case (Figure 5-33)
One PM2.5 × 12.0 screw
hinge to the bottom case
Three PM2.5 × 6.0 screws
hinge to the bottom case
that secure the cable bracket
1
that secures the pivot arm
2
3 that secure the pivot arm
.
4
Maintenance and Service Guide