Table of Contents
Advertisement
3.7 Sensor Menu Map
Top Menu
Output Operation
Teach Process Selection
Offset Percentage
Response Speed
Output Timing Delays
Delay Timer
Available when
set to "on"
Available when
set to "1Sh"
Input Wire Function
Sensitivity
Cut-off Output Operation
Display Read
Exit Setup
Reset to Factory Defaults
Sub Menu
BOTH
sets
selection
BOTH
Light Operate
Dark Operate
BOTH
Two-Point Static Teach
Dynamic Teach
Window Set
Light Set
Dark Set
BOTH
(min, 10, 20, 30, 40, 50) - Window & Light Set options (20% is default for Light Set and Window)
(min, 25, 50, 100, 200) - Dark Set options ( 50% is default for Dark Set)
Pct menu present when teach is set to Window, Light, or Dark
BOTH
set Response Speed to 250 microseconds
set Response Speed to 1 millisecond
set Response Speed to 5 milliseconds
Response Speed menu not present when Input Wire Function set to Master or Slave
BOTH
off: no delays enabled
on: enable on and/or off delay (set value in Delay Timer menu)
1 Shot, fixed output pulse duration
LO = Single fixed duration, On pulse when moving into light state
BOTH
DO = Single fixed duration, On pulse when moving into dark state
ms
to
sec range, set Delay Timer value (seconds have decimal)
Menu not present when
("ond" and "ofd" default to 0, "dt1" defaults to 1 or 10 depending on response speed setting)
BOTH
off: input is not active, ignore pulses
laser off when pulled low
laser on when pulled low
set: Remote Teach input
Master sync line for two sensor cross talk avoidance (response speed is 25 ms)
Slave sync line for two sensor cross talk avoidance (response speed is 25 ms)
BOTH
standard sensitivity
high sensitivity
low sensitivity
BOTH
Output follows LO/DO selection; sensor treats target in background as dark state
Output switches OFF when target is beyond background suppression distance
Output switches ON when target is beyond background suppression distance
CtO menu is not present on the 300 mm LD models
BOTH
display on
display on, inverted
display off (enters sleep mode after 60 seconds)
display off, inverted (enters sleep mode after 60 seconds)
BOTH
end: exit setup
BOTH
no: do not reset to factory defaults
yes: reset to factory defaults
Figure 13. Setup Mode Menu Map
www.bannerengineering.com - Tel: 763.544.3164
(
default setting)
is set to "off"
Q3X Laser Contrast Sensor
21
Advertisement
Table of Contents
