Canon TZ-5300 Online Manual page 106

• • If the leading edge of the roll paper is cut crooked or folded, it may not be fed correctly. Cut the
leading edge of the roll paper with scissors or the like and straighten it.
• • Make sure that the roll paper is not slack before loading it.
• • Take up any slack in the roll paper before loading it.
• • If the paper is wrinkled or warped, straighten it out before loading it.
• Load the roll so that there is no gap between the right edge of the paper and the Roll Holder. •
• Depending on the paper, the roll paper may be scratched when being fed and not feed well. In •
this case, you must feed the paper manually after setting Paper retention settings to Release on
the touch screen. Lift the release lever, advance the roll paper until its leading edge appears on
platen, lower the release lever, and then proceed to the next step. However, if Paper retention
settings is set to Release, automatic switching of the upper and lower rolls is not possible.
• • When selecting Enable in Roll paper auto feed.
Go to step 6.
• When selecting Disable in Roll paper auto feed. •
Pull out roll paper evenly, insert leading edge between roll paper and arrows (A) directly beneath
it, and feed roll paper until you hear a sound.
106