Canon TZ-5300 Online Manual page 948

1024
Cause
Possible causes include the following.
• Roll paper is empty in Roll 1 (Upper).
• There is remaining roll paper in Roll 1 (Upper), but because it could not be advanced, it could not be
detected.
What to Do
• • The roll paper has run out
Follow the steps below to replace the used roll with a new roll of the same type and size.
1. Open the maintenance cover, lift up the release lever, and remove the roll paper. 1.
Removing the Roll from the Printer
2. Load the new roll. 2.
Loading Rolls in the Printer
3. 3. If "There is a job which has not been printed yet. Do you want to print this job?" appears on
the touch screen, tap Yes.
Printing will resume, starting from the page on which the error occurred.
• • Feed stopped because the end of the paper roll is attached to the core with tape
Remove the used roll paper and insert a new roll paper.
Removing the Roll from the Printer
Loading and Printing on Rolls
• Feed stopped because the remaining paper roll is too heavy •
It may be helpful to change the printing mode, which will change the paper feed timing.
If using Windows, select a higher Print Quality setting under Advanced Settings in the printer driver.
If using macOS, select Quality & Media in the printer driver, and then select a higher Print Quality
setting.
Setting the Print Quality Level (Custom)
Setting the Print Quality Level (Custom) (macOS)
Note
• To stop printing, tap Stop.
(Windows)
948