Supermicro SuperServer SYS-2029U-T Series User Manual page 173

Notes for Installing in the Upper Left-side Position (5/6)
•
Break off the necessary portions of the shroud to allow for cables. In particular, remove
some tabs on the top, as indicated.
•
Position the shroud as shown in Figure F-3. The right wall of the shroud just covers CPU2.
•
Routing the GPU power cables: Guide the cables up between the GPU and the shroud,
then over the top of the shroud and down to the GPU_PWR3 or GPU_PWR4 connector on
the motherboard. Make cables flat as possible. It is normal for the shroud to bend slightly
under the cables.
Route GPU power cable by
this edge of the shroud.
Figure F-7. Installing a GPU on the Upper Left-side
Notes for Installing in the Lower Left-side Position (7/8)
Installation of a GPU in the 7/8 position is not supported without consultation with Supermicro
due to thermal limitations. If the 7/8 position is used, mounting requires MCP-120-82904-0N
bracket from accessory box.
Appendix F GPUs in 2U Ultra Systems
Break off portion to
allow cables.
173
Installing the Air Shroud for
the Left-side GPU (MCP-310-
21903-0B)
Slot for
Shroud Tabs