Supermicro SuperServer SYS-2029U-T Series User Manual page 172

SuperServer 2029U-T Series User's Manual
5. Remove the two screws on the fan housing that secure the default air shrouds. (See
Figure F-2)
6. Place the appropriate air shroud (see the following notes). Insert the shroud tabs into
the slot at the top of the fan housing.
7. Place the riser card bracket with GPU into the chassis. First, insert the cables and front
end of the GPU into the throat of the air shroud. Then align and insert the riser card into
the motherboard slot while aligning the bracket into the chassis.
8. Secure the bracket into the chassis. At the chassis rear, flip the small black plastic flip-
lever to secure it. For the Ultra riser (center) bracket, use the thumbscrew to secure the
bracket to the standoff in the chassis center. For either bracket, an optional screw can
secure it to the chassis side.
9. Route the GPU power cable and plug it into the motherboard.
10. Close and power up the system.
172