Troubleshooting - Compaq Armada M700 Series Maintenance And Service Manual

2
chapter
T
ROUBLESHOOTING
Follow these basic steps when beginning the troubleshooting process:
1. Complete the preliminary steps listed in Section 2.1.
2. Run the Power-On Self-Test (POST) as described in Section 2.3.
3. Run Computer Setup as described in Section 2.5.
4. If you are unable to run POST or if the problem persists after running POST,
perform the recommended actions described in the diagnostic tables in Section 2.5.
Follow these guidelines when troubleshooting:
I Complete the recommended actions in the order in which they are given.
I Repeat POST after each recommended action until the problem is resolved and the
error message does not return.
I When the problem is resolved, stop performing the troubleshooting steps and do not
complete the remaining recommended actions.
I Refer to Chapter 5 for recommended removal and replacement procedures.
I If the problem is intermittent, check the computer several times to verify that the
problem is solved.
The following table describes the troubleshooting actions:
If You Want To:
Check for POST error messages
Perform any of the following:
I
Check the system configuration
I
Set the system power management
parameters
I
Return the system to its original
configuration
I
Check system configuration of installed
devices
Then Run:
POST
Computer Setup

Troubleshooting 2-1