Temperature Measurement; Temperature Measurement Configuration - HIKVISION DS-2TD4136T-25 User Manual

Thermal bi-spectrum network speed dome
Hide thumbs Also See for DS-2TD4136T-25:
Table of Contents

Advertisement

User Manual of Thermal Network Speed dome
4. Check the checkbox of Display Detection Frame on Video to display the frame and
alarm line on stream. (Optional)
The function of ship detection is only supported for some models.
For better effect, make sure there is no sky in your scene.
If you moved the camera to other direction when you enabled the ship
detection function, the device will move back to the saved scene 15 s later.
5. Enter the device height in the textbox as the height of device above the water level.
6. Draw the ship detection area and the alarm lines.
(1) Click Draw Area. Click the mouse on the live video image to draw a ship
detection area and right click to finish the drawing. The alarm will be
uploaded when ship is detected in this area.
(2) Click Draw Alarm Line. Click the mouse on the live video to draw an alarm
line and right click to finish the drawing. The device alarms and counts the
ship number when ships are detected in the area and the ship information
will be displayed on the right.
Make sure the alarm line is longer than the width of ship detection area.
7. Check the checkbox to select the linkage method taken for the alarm input. Refer to
Step 3 in Section 5.2.1 Configuring Motion Detection. In the field of Other Linkage, you
can check the checkbox to enable the alarm output (The alarm output number varies
depending on device ability).
8. Click

5.4 Temperature Measurement

Purpose:
When you enable this function, it measures the actual temperature of the spot being
monitored. The device alarms when temperature exceeds the temperature threshold
value.
Before You Start:
Enter Configuration > Advanced Configuration > System > VCA Resource Type to select
Temperature Measurement + Behavior Analysis as VCA Resource Type.

5.4.1 Temperature Measurement Configuration

Steps:
1. Enter Configuration > Temperature Measurement > Basic Settings Configuration.
© Hikvision
to save the settings.
58

Advertisement

Table of Contents
loading

Table of Contents