Chapter 2 Network Connection; Setting The Network Speed Dome Over The Lan; Wiring Over The Lan - HIKVISION DS-2TD4136T-25 User Manual

User Manual of Thermal Bi-spectrum Network Speed dome

Chapter 2 Network Connection

Before you start:
If you want to set the network speed dome via a LAN (Local Area Network), please

refer to Section 2.1.
If you want to set the network speed dome via a WAN (Wide Area Network), please

refer to Section 2.2.

2.1 Setting the Network Speed dome over the LAN

Purpose:
To view and configure the speed dome via a LAN, you need to connect the network speed
dome in the same subnet with your computer, and install the SADP or client software to
search and change the IP of the network speed dome.
For the detailed introduction of SADP, please refer to Appendix.

2.1.1 Wiring over the LAN

The following figures show the two ways of cable connection of a network speed dome
and a computer:
Purpose:
 To test the network speed dome, you can directly connect the network speed dome to
the computer with a network cable as shown in Figure 2-1.
Refer to the Figure 2-2 to set the network speed dome over the LAN via a switch or a

router.
© Hikvision
Network Cable
Figure 2-1 Connecting Directly
4