HIKVISION DS-2TD4136T-25 User Manual page 46

User Manual of Thermal Network Speed dome
2. Click
3. Select the timeline of a certain day, click and drag the left button of the mouse to
set the capture schedule (the start time and end time of the recording task).
4. After you set the scheduled task, you can click
days (optional).
5. After setting the capture schedule, you can click a capture segment to display the
segment capture settings interface to edit the segment capture parameters.
(optional)
6. Click
stream type of the capture.
7. Click
8. Check the Enable Timing Snapshot checkbox to enable continuous snapshot,
and configure the schedule of timing snapshot. Check the Enable
Event-triggered Snapshot checkbox to enable event-triggered snapshot.
9. Select the format, resolution, quality of the snapshot.
10. Set the time interval between two snapshots.
11. Click
Uploading to FTP
Please make sure that the FTP server is online.
You can follow below configuration instructions to upload the snapshots to FTP.
 Upload continuous snapshots to FTP
Steps:
1) Configure the FTP settings and check Upload Picture checkbox in FTP Settings
interface. Please refer to Section 7.1.2 Configuring FTP Settings for more details
to configure FTP parameters.
2) Check the Enable Timing Snapshot checkbox.
3) Click Edit to set the snapshot schedule. Refer to Section 5.2.1 Configuring
Motion Detection.
 Upload event-triggered snapshots to FTP
© Hikvision
to enter the Capture Schedule interface.
Figure 5-4 Segment Snapshot Settings
to enter the advanced setting interface. You can select the
to enter the Capture Parameters Interface.
to save the settings.
38
and copy the task to other