Trouble Case; Cannot Access Web Config - Epson SureColor SC-T7700D Administrator's Manual

Administrator's Guide
2. Select Wi-Fi Direct.
The Wi-Fi Direct information is displayed.
3. Tap Start Setup.
4. Tap Change Settings.
5. Select Disable Wi-Fi Direct.
6. Tap the Disable the settings.
7. When a completion message is displayed, close the screen.
The screen automatically closes after a specific length of time.
Restoring the Network Settings from the Control Panel
You can restore all network settings to their defaults.
1. Select Menu on the home screen.
2. Select General Settings >System Administration >Restore Default Settings > Network Settings.
3. Check the message, and then select Yes.
4. When a completion message is displayed, close the screen.
The screen automatically closes after a specific length of time.

Trouble Case

Cannot Access Web Config

The IP address is not assigned to the printer.
A valid IP address may not be assigned to the printer. Configure the IP address using the printer's control panel.
You can confirm the current setting information with a network status sheet or from the printer's control panel.
Web browser does not support the Encryption Strength for SSL/TLS.
SSL/TLS has the Encryption Strength. Web Config can be opened by the web browser that supports the bulk
encryptions as follows. Check your browser's encryption support.
❏ 80bit: AES256/AES128/3DES
❏ 112bit: AES256/AES128/3DES
❏ 128bit: AES256/AES128
❏ 192bit: AES256
❏ 256bit: AES256
Solving Problems
65