Epson SureColor SC-T7700D Administrator's Manual page 31

Administrator's Guide
Items
Secure Connection
Certificate Validation
POP3 Server Address
POP3 Server Port Number
Related Information
"Configuring a Mail Server" on page 29
&
Checking a Mail Server Connection
You can check the connection to the mail server by performing the connection check.
1. Access Web Config and select the Network tab > Email Server > Connection Test.
2. Select Start.
The connection test to the mail server is started. After the test, the check report is displayed.
Related Information
"Accessing Web Config" on page 24
&
"Logging on to the Printer Using Web Config" on page 48
&
"Mail Server Connection Test References" on page 31
&
Mail Server Connection Test References
Messages
Connection test was successful.
Function Settings
Select the encryption method of the communication to the mail server.
None
SSL/TLS
STARTTLS
The certificate is validated when this is enabled. We recommend this is set to Enable. To set
up, you need to import the CA Certificate to the printer.
If you select POP before SMTP as the Authentication Method, enter the POP3 server
address between 0 and 255 characters using A-Z a-z 0-9 . - . You can use IPv4 or FQDN
format.
If you select POP before SMTP as the Authentication Method, enter a number between 1
and 65535.
This message appears when the connection with the server is successful.
31
Settings and Explanation
If you select POP before SMTP in Authentication Method,
the connection is not encrypted.
This is available when Authentication Method is set to Off
or SMTP AUTH. Communication is encrypted from the start.
This is available when Authentication Method is set to Off
or SMTP AUTH. Communication is not encrypted from the
start, but depending on the network environment, whether
the communication is encrypted or not is changed.
Cause