Advertisement
Step 20: Attach Rock Rail
A: Place 1 (1765) Rock Rail 17" from the already installed (1765) Rock Rail so the top measures 3/8" above
(1764) Floor Front then attach both (1765) Rock Rails to (1764) Floor Front with 2 (S15) #8 x 1-3/4" Wood Screws
per board and second (1765) Rock Rail to (1767) Lower Front with 2 (S15) #8 x 1-3/4" Wood Screws. (fig. 20.1 &
20.2)
B: Attach (1779) CE Access Board to the top of each (1765) Rock Rail as shown in fig. 20.3. Make sure (1779)
CE Access Board is flush to the outside and top edges of each Rock Rail. Attach using 4 (S2) #8 x 1-1/2" Wood
Screws. (fig. 20.3)
C: 2-5/16" down from the bottom of (1779) CE Access Board attach 2 (1776) CE Rock Board As and 2 (1777) CE
Rock Board Bs in any order so they are staggered to ensure the rock holes do not form a straight line. Make sure
the sides are flush to the outside edges of each (1765) Rock Rail. Attach using 4 (S2) #8 x 1-1/2" Wood Screws
per board. Make sure the gap between boards are evenly spaced 2-5/16" and do not exceed 2-1/2". (fig. 20.3)
D: Place 1 rock on each (1776) CE Rock Board A and (1777) CE Rock Board B and attach using 1 (PB2) 1/4 x
1-1/4" Pan Bolt (with lock washer, flat washer and barrel nut) and 1 (S10) #8 x 1" Pan Screw per rock. The screw
must be in the hole directly under the Pan Bolt, it will stop the rock from spinning. (fig. 20.3 and fig. 20.4)
Fig. 20.1
S15
1765
17"
1767
Wood Parts
2 x
CE Rock Board A 1 x 6 x 17"
1778
2 x
CE Rock Board B 1 x 6 x 17"
1777
1 x
CE Access Board 1 x 6 x 17"
1779
1 x
Rock Rail 2 x 3 x 42-3/4"
1765
1764
S15
3/8"
S15
Fig. 20.4
1/4" Flat
Washer
1/4" Lock
Washer
PB2
20 x
6 x
4 x
4 x
Fig. 20.3
Fig. 20.2
1764
1765
Barrel nut
Rock
S10
Hardware
#8 x 1-1/2" Wood Screw
S2
S15
#8 x 1-3/4" Wood Screw
#8 x 1" Pan Screw
S10
1/4 x 1-1/4 Pan Bolt
PB2
(1/4" lock washer, 3/16" flat washer & 1/4" barrel nut)
36
S2
x 4 per
board
S15
Other Parts
1 x Rock (pkg of 4)
1779
1765
1778
1777
1778
2-5/16" Not
to exceed
2-1/2"
1777
Advertisement
