KidKraft F24148E Installation And Operating Instructions Manual page 18

Step 3: Swing Beam
A: Place (4919) SW Rail Block in the centre between (1773) CE SW Beam Front and (1772) CE SW Beam Back
and attach beams with 1 (H8) 1/4 x 4-1/4" Hex Bolt (with flat washer, lock washer and t-nut). (fig. 3.1 & 3.2)
B: Attach Swing Beam Assembly to the side of the Swing End Assembly with the overhang (fig. 3.3) using 1 (G5)
5/16 x 4-1/2" Hex Bolt (with lock washer, flat washer and t-nut) in the top hole of Triangle Plate and 1 (G8) 5/16 x
2" Hex Bolt (with 2 flat washers and lock nut) in the bottom hole of Triangle Plate. (fig. 3.3) Make sure Swing End
Assembly flares out at an angle. (fig 3.4)
Fig. 3.4
Wood Parts
1 x SW Rail Block 2 x 4 x 5-3/8"
4919
Fig. 3.1
1 x 1/4 x 4-1/4" Hex Bolt
H8
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1 x 5/16 x 4-1/2" Hex Bolt
G5
(5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
1 x 5/16 x 2" Hex Bolt
G8
(5/16" flat washer x 2, 5/16" lock nut)
Fig. 3.2
Side with
Overhang
Hardware
18
4919
1773
1772
H8
Fig. 3.3
G8
G5