Cpu Usage - ZyXEL Communications NWA1123ACPRO-EU0101F User Manual

Table 20 Dashboard (continued)
LABEL
WLAN Interface
Status Summary
Status
MAC Address
Radio
Band
OP Mode
Channel
Antenna
Station
AP Information
All Sensed Device
Un-Classified AP
Rogue AP
Friendly AP

4.2.1 CPU Usage

Use this screen to look at a chart of the NWA/WAC's recent CPU usage. To access this screen, click CPU
Usage in the dashboard.
Figure 28 Dashboard > CPU Usage
Chapter 4 Dashboard
DESCRIPTION
This displays status information for the WLAN interface.
This displays whether or not the WLAN interface is activated.
This displays the MAC address of the radio.
This indicates the radio number on the NWA/WAC.
This indicates the wireless frequency band currently being used by the radio.
This shows - when the radio is in monitor mode.
This indicates the radio's operating mode. Operating modes are AP (MBSSID), MON
(monitor), Root AP or Repeater.
This indicates the channel number the radio is using.
This indicates the antenna orientation for the radio (Wall or Ceiling).
This field is not available if the NWA/WAC does not allow you to adjust antenna orientation
for each radio using the web configurator or a physical switch. Refer to
and Table 2 on page 12 to see if your NWA/WAC has an antenna switch.
This displays the number of wireless clients connected to the NWA/WAC.
This shows a summary of connected wireless Access Points (APs).
This sections displays a summary of all wireless devices detected by the network. Click the
link to go to the Monitor > Wireless > Detected Device screen.
This displays the number of detected unclassified APs.
This displays the number of detected rogue APs.
This displays the number of detected friendly APs.
NWA / WAC Series User's Guide
53
Table 1 on page 11