Supero SUPERSERVER 2028TP-HTR User Manual page 3

About This Manual
This manual is written for professional system integrators and PC technicians.
It provides information for the installation and use of the SuperServer
2028TP-HTR/HTTR/HTFR. Installation and maintainance should be performed by
experienced technicians only.
The SuperServer 2028TP-HTR/HTTR/HTFR is a high-end server based on
the SC217HQ+-R2K02B 2U rackmount chassis and the dual processor
X10DRT-P/PT/PIBF serverboard. Both models have an IPMI LAN port and four
serverboard nodes with three hot-swap Hard Disk Drives (HDD) each per node.
Manual Organization
Chapter 1: Introduction
The first chapter provides a checklist of the main components included with
the server system and describes the main features of the X10DRT-P/PT/PIBF
serverboard and the SC217HQ+-R2K02B chassis.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the SuperServer
2028TP-HTR/HTTR/HTFR into a rack and check out the server configuration prior to
powering up the system. If your server was ordered without processor and memory
components, this chapter will refer you to the appropriate sections of the manual
for their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions and
information provided by the control panel on the chassis as well as other LEDs
located throughout the system.
Chapter 4: Standardized Safety Warnings
You should thoroughly familiarize yourself with this chapter for a general overview
of safety precautions that should be followed when installing and servicing the
SuperServer 2028TP-HTR/HTTR/HTFR.
Chapter 5: Advanced Serverboard Setup
Chapter 5 provides detailed information on the X10DRT-P/PT/PIBF serverboard,
including the locations and functions of connections, headers and jumpers. Refer
to this chapter when adding or removing processors or main memory and when
reconfiguring the serverboard.
Preface
iii
Preface