Supero SUPERSERVER 2028TP-HTR User Manual page 91

SUPERSERVER 2028TP-HTR/HTTR/HTFR USER'S MANUAL
Installing Expansion Cards (Figure 6-14)
1. Disconnect the chassis from any power source, lay the chassis on a flat
surface, and open the chassis cover.
2. Pull out the serverboard node drawer from the chassis.
3. Pull open the expansion card PCI slot clip in the rear of the serverboard node
drawer.
4. Remove the PCI PCI slot shield.
5. Place the expansion card into the serverboard node drawer.
6. Slide the expansion card into the rear riser card PCI slot and fit the expansion
card bracket with the opening in the rear of the serverboard node drawer.
7. Close the expansion card PCI slot clip.
8. Close the cover, reconnect the power supply and power-up the chassis.
Add-on Card
Bracket
Add-on Card
Bracket Screws
Figure 6-14. Installing the Expansion Card
PCI Slot
Shield
Add-on Card
Riser Card
6-16