Table of Contents
Advertisement
26
www.electrolux.com
WARNING!
Make sure that the heating
element is correctly installed
and that it does not fall
down.
10.7 Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
The lamp glass cover is at
the back of the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.
11. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
You cannot activate the
appliance.
You cannot activate the
appliance.
2. Clean the glass cover.
3. Replace the oven lamp with a
4. Install the glass cover.
10.8 Removing the drawer
The drawer below the oven can be
removed for cleaning.
1. Pull the drawer out until it stops.
2. Lift the drawer slightly, so that can be
To install the drawer, follow the
procedure in reverse.
Possible cause
The appliance is not con‐
nected to an electrical sup‐
ply or it is connected incor‐
rectly.
The fuse is released.
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
WARNING!
Do not keep flammable
items (such as cleaning
materials, plastic bags, oven
gloves, paper or cleaning
sprays) in the drawer. When
you use the oven, the
drawer can become hot.
There is a risk of fire
lifted upwards at an angle of the
drawer guides.
Remedy
Check if the appliance is
correctly connected to the
electrical supply.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse releases
again and again, contact a
qualified electrician.
Advertisement
Table of Contents
