Standard Phone Line Connections; Wiring The Ac Transformer; Figure 4.Êêtelephone Line Connections - First Alert FA162C Installation Instructions Manual

2-partitioned
Hide thumbs Also See for FA162C:
Table of Contents

Advertisement

Standard Phone Line Connections

TERMINALS
ON CONTROL

Wiring The AC Transformer

ÊÊÊ
ÊÊ 1321
ÊÊÊÊÊÊÊÊÊÊÊÊÊ4300
The wiring connections shown here are not applicable if the FA4285 Phone
Module is used. Refer to the FA4285 Phone Module section for information
regarding phone line connections, which are different than those shown here.
Incoming phone line and handset wiring is connected to the main terminal
block (via a RJ31X jack) as follows (also see Figure 4):
Term. 21: Local Handset (TIP Ð Brown*)
Term. 22: Local Handset (RING Ð Gray*)
Term. 23: Incoming Phone Line (TIP Ð Green*)
Term. 24: Incoming Phone Line (RING Ð Red*)
Colors of wires in Direct Connect Cord.
Incoming
Handset
Telco Line
26
27
28
29
23
24
21
22
CONNECT
Figure 4. Telephone Line Connections
Wire the 1321 transformer to terminals 1 and 2 on the control board. See
wiring table below for wire gauge to use.
Caution must be taken when wiring the transformer to the control panel to
guard against blowing the fuse inside the transformer (the fuse is non-
replaceable).
If you are going to use a 4300 transformer interface (required if Powerline
Carrier devices are going to be used), connect the 4300 transformerÕs
terminals as follows:
a. Terminals 1, 3 (AC), and 2 (Ground) to control board terminals 1, 2, and
25, respectively (see Figure 5). See table below for wire gauge to use.
WIRING TABLE
Distance of Transformer
From the Control Panel
Up to 50 feet
50Ð100 feet
100-250 feet
Wiring to the AC Transformer must not exceed 250 feet using 16 gauge wire.
The voltage reading between terminals 1 and 2 of the control must not fall
below 16.5VAC or an "AC LOSS" message will be displayed.
Do not plug the transformer into the AC outlet until you are instructed to do
so later in the manual.
IF THE PANEL IS NOT CONNECTED TO A PROPER
EARTH GROUND, YOU MAY GET FALSE TELEPHONE
LINE CUT INDICATIONS (IF THE TELEPHONE LINE
25
30
MONITOR HAS BEEN PROGRAMMED IN FIELD 92).
EARTH GROUND
INCOMING TELCO LINE
DIRECT
TIP
CORD
RJ31X
RING
JACK
PLUG
Wire Gauge
To Use
# 20
# 18
# 16
–12–
IMPORTANT!
PREMISES
PHONES

Advertisement

Table of Contents
loading

Table of Contents