Cropping And Displaying Part Of An Image (Digital Ptz) - Canon VB-R13VE H2 Manual

Move the frame to the area you would like to magnify and resize the frame as desired.
3
Move or Resize by Dragging
Press the mouse button inside the frame and drag it to move the preview frame.
If you press the mouse button and drag outside the frame, a new preview frame will be drawn.
You can resize the preview frame by dragging an edge of the frame.
Move by Clicking
If you click outside the frame, the preview frame will move and center on that point.
Move Using the Sliders/Resize
You can use the pan and tilt sliders in the video display area to move the preview frame. You can use the zoom
slider to resize the image within preview frame.
Note
The Viewer PTZ uses digital zoom, so the higher the digital zoom ratio, the lower the quality of the video.
Exiting Viewer PTZ
The Viewer PTZ exits if you perform one of the following operations.
• Click the [Viewer PTZ] button to disable it.
• Click the [Digital PTZ] button to start the Digital PTZ.
Note
You can also perform the following operations to retain the zoomed view of the video display area without exiting the Viewer PTZ
while the [Viewer PTZ] button is active (purple).
– Click the [Close] button on the control display area to close the Viewer PTZ panel.
– Click the snapshot tab or panorama display tab (

Cropping and Displaying Part of an Image (Digital PTZ)

You can use the Digital PTZ panel to crop and display part of a camera image in the image display area.
Note
If you enable Digital PTZ while receiving H.264 video, the received video is switched to JPEG.
64
Preview Frame
H730 S80x S90x
HM4x S30 S31
) to switch the panel in the control display area.