Table of Contents
Advertisement
7.
DO NOT wear loose clothing while operating this machine. Roll up sleeves or button sleeves at
the cuff.
8.
DO NOT place hands near, or in contact with sanding belt or disc during operation.
9.
Perform machine inspections and maintenance service promptly when called for.
10. Any problem, with the exception of tracking, that is concerned at all with any moving parts or
accessories must be investigated and corrected with the power disconneted, and after every-
thing has come to a complete stop.
11. NEVER leave the machine running unattended.
12. Replace belts or sleeves when they become worn.
It cannot be assumed that additional safety measures are not needed under particular or exceptional
circumstances or conditions. Consider safety at all times.
Before you test your G1173 Sander on some scraps, give it a quick inspection.
1.
Are all fasteners, nuts, and bolts tight?
2.
Is the sanding belt tracking properly?
3.
Is the dust hood securely fastened?
4.
Is the table adjusted to the proper angle?
5.
Is the sander plugged in to a grounded outlet of the proper voltage?
The G1173 Oscillating Edge Sander requires a 4" x 24" sanding belt. The vertical sanding drum is
4
1
/
" high and has a 1
4
pose sanding, a 60 grit (coarse) belt for fast material removal, and a 150 grit (fine) belt for finish work.
Refer to Grizzly's current catalog for more information.
Your sander's motor has shielded ball bearing housings that do not require additional lubrication.
X. TEST RUN
MISCELLANEOUS
1
/
" diameter. Grizzly recommends a 100 grit (medium) belt for general pur-
2
- 9 -
Advertisement
Table of Contents
