Table of Contents
Advertisement
Figure 3 shows lifting out
the vertical platen
6.
Reinstall the small insert plate. Install the large insert plate (#436) in the space created by
removal of the vertical platen. Tighten with the 5mm flat headed screws (#407) provided.
7.
Slide the sanding sleeve (#116) over the drive wheel (#102). It should be a tight fit.
8.
Install the collar (#107) and replace the Allen screw and washer that were removed from the
drive wheel in step 3.
Vertical drum sanding operations may now begin.
IMPORTANT: The sanding drum is not perfectly centered on its axis. This apparent "wobble" is what
triggers the oscillating mechanism. In order to get extended life from your sanding sleeve, we rec-
ommend removing it when the grit becomes loaded, rotating it
on the spindle.
Simply reverse steps 1-8 above to switch back to oscillating edge sanding.
Earlier in this manual we reviewed safety guidelines that apply to all power tools. This section will
address safety rules specific to your Model G1173 Sander.
1.
ALWAYS wear eye protection. Wear a respirator if machine operation produces dust.
2.
Be sure to observe electrical requirements such as fuse sizing, wire sizing, and grounding.
3.
Ensure that the switch is in the off position before plugging in the cord.
DO NOT stand directly in line with sanding accessories when turning machine on.
4.
7.
DO NOT jam workpiece against the sanding belt or spindle during operation. Firmly grasp the
workpiece in both hands and ease it against the sanding belt or spindle using light pressure.
IX. SANDER SAFETY
- 8 -
Figure 4 shows the vertical spindle
attachment ready for use.
1
/
of a revolution, and reinstalling it
3
Advertisement
Table of Contents
