Test Run - Grizzly G0723 Owner's Manual

To connect a dust collection hose:
Fit a 2" dust hose over the dust port shown
1.
in Figure 7, and secure in place with a hose
clamp.
Tug the hose to ensure it does not come
2.
off. Note: A tight fit is necessary for proper
performance.
Dust Port
Figure 7. Location to install dust hose.

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
Model G0723 (Mfd. Since 03/24)
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run the machine:
Clear all setup tools away from the machine.
1.
Connect the machine to the power source by
2.
inserting the power cord plug into a matching
receptacle.
The switch can be disabled by removing the key,
as shown below. Disabling the switch in this man-
Turn the machine ON, verify motor operation,
ner can prevent unauthorized operation of the
3.
and then turn machine OFF.
machine, which is important if it is not kept inside
an access-restricted building or in a location
The motor should run smoothly and without
where children may be present.
unusual problems or noises.
IMPORTANT: Disabling the switch only restricts
Remove the switch disabling key, as shown
its function. It is not a substitute for disconnecting
4.
in Figure 8.
machine from power when adjusting or servicing.
Figure 8. Disabling switch by removing key.
Try to start the machine with the paddle
5.
switch.
— If the machine does not start, the switch
disabling feature is working as designed.
— If the machine does start, immediately
disconnect power. The switch disabling
feature is not working correctly. This safe-
ty feature must work properly before pro-
ceeding with regular operations. Call Tech
Support for help.
-15-