Test Run; Recommended Adjustments - Grizzly G0458ZX Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the switch disabling key disables the switch
properly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpected
results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
Clear all setup tools away from machine.
1.
Lift both caster lock pedals to lower feet to
2.
floor and stabilize machine.
Connect machine to power supply.
3.
Turn machine ON, verify motor operation,
4.
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
Model G0458ZX (Mfd. Since 04/24)
Remove switch disabling key, as shown in
5.
Figure 18.
Figure 18. Removing switch key from paddle
switch.
Try to start machine with paddle switch. The
6.
machine should not start.
— If machine does not start, switch disabling
feature is working as designed.
— If machine does start, immediately turn
machine OFF and disconnect from power.
Switch disabling feature is not working
correctly. This safety feature must work
properly before proceeding with regular
operations. Call Tech Support for help.
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables involved
with shipping, some of these adjustments may
need to be repeated to ensure optimum results.
Tensioning V-Belt ................................ Page 33
Tracking & Tensioning Conveyor Belt .. Page 35
Aligning Table to Sanding Drum........ Page 38
-19-