Grizzly G0645 Owner's Manual page 17

3.
Lift the headstock to the top position using
the hand lever. Position the depth stop so it
contacts the top of the headstock, as shown
in Figure 10, and secure the lock knob so the
headstock does not move.
Depth Stop
Figure 10. Depth stop contacting headstock.
4. Snap the gas spring ball sockets onto the ball
studs, as shown in Figures 11 & 12.
Tip: It may help to use a flat head screwdriver
to leverage the bottom gas spring ball socket
onto the ball stud.
The headstock must be locked in place
before the gas spring is installed. Serious
personal injury can occur if the headstock
drops during installation.
Figure 11. Gas spring attached to top of
headstock.
G0645 Benchtop Mortising Machine
Ball Stud
Ball Stud
Figure 12. Gas spring attached to bottom of
column.
5.
Install the tool storage rack, as shown in
Figure 13, with the M6-1 x 15 Phillips head
screws already attached to the headstock.
Figure 13. Tool storage rack installed.
CRUSHING HAZARD!
Have an assistant hold the headstock during
the following step. The headstock is heavy
and could cause serious personal injury if
not supported.
6. Remove the four M8-1.25 x 25 hex bolts,
flat washers and lock washers securing the
column to the base, shown in Figure 14, and
temporarily lay the headstock on its side on
the workbench.
Figure 14. Hex bolts and washers securing
column to base.
-15-