This update covers changes made to the machine after the owner's manual was printed. All page num-
ber references refer to the owner's manual for this machine. Keep this update with your owner's man-
ual for future reference. If you have questions, contact Tech Support at (570) 546-9663 or by email at
techsupport@grizzly.com.
Machine Inventory
The fence assembly and fence bracket are no
longer pre-installed on the jointer assembly by
the factory for shipping, as shown in Figure 3 on
G0656 Manual Page 11. These items have been
added to the machine inventory (Figure 1). Refer
to the owner's manual for the rest of the inven-
tory.
Wood Crate (Figure 1):
A. Fence Bracket ........................................... 1
B. Fence Assembly ........................................ 1
A
Figure 1. New inventory items.
The items below have been added to the original
list of included assembly fasteners:
Assembly Fasteners
•
Cap Screws M8-1.25 x 35 (Fence) ............ 4
•
Lock Washers 8mm (Fence) ...................... 4
•
Flat Washers 8mm (Fence) ........................ 4
•
Key 4 x 4 x 12 (Right Handwheel) ............. 1
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
(See Page 11)
Qty
B
Qty
COPYRIGHT © FEBRUARY, 2008 BY GRIZZLY INDUSTRIAL, INC.
#BL10444 PRINTED IN CHINA
MODEL G0656
8" JOINTER w/BUILT-IN
MOBILE BASE
MANUAL UPDATE
Clean Up
(See Page 13)
The following sliding surfaces must be cleaned:
•
Fence carriage
•
Fence bracket
Assembly
(See Page 14)
Assembly of the fence bracket, fence carriage
assembly, and handwheels has changed. Steps
2-5 below replace Steps 15-17 on Page 15 of the
G0656 Owner's Manual.
1.
Follow Steps 1-14 on Pages 14 & 15.
2.
Align the mounting holes on the fence bracket
and jointer, and fasten with the M8-1.25 x 35
cap screws, flat washers and lock washers,
as shown in Figure 2. Do not fully tighten the
fasteners yet.
Fence
Bracket