Table of Contents
Advertisement
Rear Camera screen example
• You cannot adjust the position of the yellow guide line "
the centre independently.
It is controlled by a system to be the centre of the two yellow guide
lines "
" and "
" on the left and right, or the central green
line "
" and red guide line "
4
Touch [
], [
], [ ] or [ ] to adjust the position of the
guide.
• Touching [Clear] clears adjustments and returns to the setting
before guide line alteration.
5
After the adjustment is completed, touch [Set].
Adjusting Guides Simultaneously
<Rear Camera>
1
Touch [Link].
The 3 vertical guides of the currently-selected guide link
together, allowing them to be adjusted simultaneously.
• Note on the yellow guide line "
The yellow guide line "
" in the centre is controlled by a system that
locates it in the centre of the two yellow guide lines, "
on the left and right, or the green line "
line "
" below. Therefore you cannot move it manually.
Turning Guide Display On/Off
Turning the selected guide off.
1
Touch [On/Off].
The currently selected guide will turn off.
2
To turn the guide on, touch [On/Off] again.
• Guides that are turned off are still adjustable.
Returning Guides to Default
1
Touch [Default].
A message window will appear.
2
Touch [OK].
Adjusted values will return to default settings.
42
-EN
" in
".
" in the centre
" and "
" on the top and red guide
Camera Interrupt Setting (Power OFF Mode)
You can set whether to display the rear camera image when the gear
lever is moved to the reverse (R) position while the unit is turned off.
You can select this item only when Camera Select is "Rear. "
Setting item:
Interrupt (Power OFF)
Setting contents:
On (Initial setting) / Off
On:
The rear camera image is displayed
Off:
The rear camera image is not displayed
CAN-I/F Setup
[CAN-I/F] is selected on the System Setup Menu screen in step 1. See
"System Setup" (page 41).
• CAN-I/F BOX should be connected before this operation.
Setting the Default Vehicle Screen
Touch the Menu screen (page 16) to display the Info mode screen, and
then set the following.
Setting item:
Default Vehicle Screen
Setting contents:
Climate / Park sensor / Last mode (Initial setting)
• For details on the Vehicle Info mode screen, see "About Vehicle Interlock
Function" (page 72).
Setting the Climate Interrupt Time
You can set the time displayed in the Climate screen.
Setting item:
Climate screen interrupt time
Setting contents:
None / 5 sec (Initial setting) / 10 sec / Continuous display
None:
The Climate screen is not displayed when you adjust the
air conditioner, etc.
5 sec/10 sec*: The screen is displayed for 5 seconds/10 seconds, then
returns to the previous screen.
Continuous
The Climate screen is continuously displayed.
"
display:
* If you set the air conditioner, etc., while the Climate screen is displayed,
the screen will continuously be displayed.
• For details, see "About Vehicle Interlock Function" (page 72).
Advertisement
Table of Contents
