Table of Contents
Advertisement
System Setup
[System] is selected on the Setup main screen in step 3. See "Setup
Operation" (page 24).
System Setup Menu screen
<Setting items>
Camera
Camera Select
1
Camera Signal*
1
Guide Adjustment*
1
Interrupt (Power OFF)*
2
CAN-I/F*
Default Vehicle Screen
Climate screen interrupt time
Parking sensor interrupt
Unit
External AP
Application
3
Alpine TuneIt App*
*1 When Camera Select is set to "Off, " you cannot select this item.
*2 CAN-I/F BOX should be connected before this operation.
*3 Set this setting after closing the Alpine TuneIt App.
The following steps 1 to 3 are common to each "Setting
item" of System Setup. See each section for details.
1
Select the desired item.
2
To switch the setting, touch [ ], [ ], [ ], [ ], or mark the
checkboxes "Off" (
) or "On" (
• If " " appears, there is a further hierarchy. Touch the desired
item.
3
Touch [ ] to return to the main source screen.
• To return to the previous List screen, touch [ ] or [ ] in the
previous page. For details, see "About Basic Operation for List
Screen" (page 14).
Camera Setup
[Camera] is selected on the System Setup Menu screen in step 1. See
"System Setup" (page 41).
You can set up items related to the Camera.
Setting item:
Setting contents:
When the camera is connected, the video input signal type can be
chosen.
Further setting item:
Setting contents:
You can adjust the camera guide position.
Setting item:
1
2
).
3
Setting the Camera Input
Camera Select
Off (Initial setting) / Rear
Off:
No camera is connected
Rear:
Rear camera is connected
Setting the Camera Signal Input
Camera Signal
NTSC (Initial setting) / PAL
Adjusting the Rear Camera Guide
Guide Adjustment
Touch [Guide Adjustment].
The camera guide adjustment screen is displayed.
Touch [Adjust].
• If [Adjust] does not appear, proceed to step 3.
Touch the guide you intend to adjust.
Guide line can also be selected by touching [
] [
].
41
-EN
Advertisement
Table of Contents
