Table of Contents
Advertisement
Setting the Time
Setting item:
Time Adjust
Additional items:
Hour / Minute
Setting content:
AM12 - PM12 or 0-23 / 0-59
Hour:
Adjust the hour.
Minute:
Adjust the minute.
• Cannot be adjusted while no GPS signal is received.
Setting Security code
You can set the system to be unusable without entering a password.
When you turn this setting to "On" and set a password, password input
is required when the system is connected to a battery and turned on for
the first time.
Setting item:
Security Code
Setting contents:
Off (Initial setting) / On
Setting the password
1
Touch the checkbox "Off" (
2
After the confirmation message appears, touch [OK].
The password setting screen is displayed.
3
Enter a password, then touch [OK].
• Enter the 6-digit number.
• Input numbers are displayed as "*".
• Touch [
] to delete an entered number.
4
Enter the same password again, then touch [OK].
The password is set and the system returns to the General Setup
Menu screen, then the checkbox of the Security Code is set to
"On" (
).
• If you forget a registered password, you can not use this unit. In this
case, service will be required.
Clearing the password
1
Touch the checkbox "On" (
The password setting screen is displayed.
2
Enter the password you have set, then touch [OK].
The password is cleared and the system returns to the General
Setup Menu screen, then the checkbox of the Security Code is
set to "Off" (
).
• Input numbers are displayed as "*".
36
-EN
) of the Security Code.
) of the Security Code.
About iLX-F903D
[About] enables you to check the Serial Number, Firmware Version,
Model Name, and to initialise various settings.
Displaying the Product Information
You can view the version information of this product. Make note of this
information and refer to it whenever you contact Alpine Tech Support
or an Alpine-authorized dealer.
Setting contents:
Serial Number / Firmware Version / Model Name
Initializing the System
You can initialise all data, to restore the factory settings. Remove the
USB flash drive, etc. from the system before operation
Setting item:
Clear All Settings
1
Touch [Reset] of "Clear All Settings."
2
After the confirmation message appears, touch [OK].
The confirmation screen appears again.
3
Touch [OK].
The system starts initialisation.
• Do not turn on/off the power, change the ignition key position or
remove the screen panel until system restart is completed.
Setting Demo mode to Off/On
This unit has a Demonstration feature for the display. When you install
and use the unit for the first time, the unit will enter demo mode
automatically. To quit demo mode, set Demo mode to Off.
Setting item:
Demo mode
Setting contents:
Off / On (Initial setting)
• If you perform an operation during the Demo mode, the demonstration
is temporarily stopped.
Advertisement
Table of Contents
