Table of Contents
Advertisement
Programmable functions
Display switch-off status
To save energy, the time display and
sensor buttons will go out after
10 minutes, and only the Start/Stop
sensor button will flash. You can alter
this setting.
However, there is no switch-off in the
event of a fault.
Options
= Off
The time display and sensor
buttons will remain lit up while
the dryer is switched on.
= On (factory setting)
The time display and sensor
buttons will go out after
10 minutes. . .
. . . if no further selection is
made after switching the dryer
on.
. . . after a program has
started.
However, the time display and
sensor buttons will remain lit
up for 10 minutes after a delay
start time has elapsed, after
the end of a program, or at the
end of the Anti-crease phase.
"Switching on" the display again
- Turn the program selector to any
position (other than ) or touch a
sensor button. This will not alter a
running program.
- Open the door while the dryer is
switched on.
74
Appliance switch-off
The dryer switches off automatically
after 15 minutes to save energy. This
time can be extended or reduced.
The dryer will switch off automatically
after 15, 20, or 30 minutes
- if no further selection is made after
switching the dryer on,
- following the end of the Anti-crease
phase,
- after a program without an Anti-
crease phase has finished.
However, there is no switch-off in the
event of a fault.
Options
= After 15 minutes (factory
setting)
= After 20 minutes
= After 30 minutes
Advertisement
Table of Contents
