Table of Contents
Advertisement
Display switch-off status
To save energy the display and sensor
controls will go out after 10 minutes
and the Start/Stop sensor will flash
slowly. You can change this automatic
switch-off function.
Options
- On
The display will go out (after
10 minutes):
– if no programme selection is made
after switching the dryer on
– during the current programme
– after the end of a programme.
- On. Not in current prog.
(factory default setting)
The display will go out (as described
above), but will remain on while the
programme is running.
You can switch the display back on by
touching any sensor.
Settings
99
Advertisement
Table of Contents
