Table of Contents
Advertisement
4. Removing the laundry at the end of the program
End of program/Anti-crease
End of program: lights up and the
Start/Stop sensor button goes out.
The dryer will switch off automatically. If
you want an Anti-crease phase after the
end of program, see "Programmable
functions", " Anti-crease".
Energy savings
- 10 minutes after the end of the
program, the Start/Stop sensor
button will begin to flash and the
display will go out.
- The dryer will switch off automatically
15 minutes after the end of the Anti-
crease phase (with programs without
an anti-crease phase, it will switch off
15 minutes after the end of the
program).
Removing the laundry
Only open the door when the drying
process has finished. Otherwise, the
laundry will not be properly dried
through and cooled down.
Pull the door open at the side with
the orange marker.
Remove the laundry.
Check that all items have been
removed from the drum!
If items are left in the dryer, they
could be damaged by over-drying
when the dryer is next used.
Turn the program selector to the
position.
Remove the lint from the 2 lint filters
in the door opening: see "Cleaning
and care", "Cleaning lint filters".
Shut the door gently.
Empty the condensed water
container.
27
Advertisement
Table of Contents
