Display Brightness; Display Switch-Off Status; Appliance Switch-Off Status; Display Maximum Load - Miele TMV 840 WP Operating Instructions Manual

Settings menu

Display brightness

The brightness of the display can be
altered.
The setting selected is shown in a bar
chart.
Factory default: a medium setting.
–
      
Dimmer
–
      
Brighter
You will see the brightness change as
the setting is selected.

Display switch-off status

To save energy the display and sen‐
sors will go out after 10 minutes and
the Start/Stop sensor will flash slowly.
You can alter this setting.
Options
–
On
The display will go out (after 10 mi‐
nutes):
– if a programme is not selected af‐
ter the dryer has been switched on
– during the current programme
– after the end of a programme.
–
On (not in current prog.)
fault setting)
The display will go out (as described
above) but will remain on while the
programme is running.
–
Off
The display will remain on (i.e. it will
never go out).
You can switch the display back on by
touching any sensor.
96
(Factory de‐

Appliance switch-off status

To save energy the dryer will switch
off automatically after 15 minutes. You
can lengthen or shorten the time.
The dryer will switch off automatically
after 10, 15 or 20 minutes,
– if no further selection is made after
switching the dryer on
– at the end of the anti-crease phase
– after a programme without an anti-
crease phase has finished.
However, there is no automatic switch-
off in the event of a fault.
Options
–
After 10 minutes
–
After 15 minutes
ting)
–
After 20 minutes

Display maximum load

After a programme is selected the
maximum load appears in the display
for a short time. You can switch this
off.
Options
– (Factory default setting)
Yes
–
No
(Factory default set‐