Tt Simulation Mode - Furuno FAR-1513-BB Operator's Manual

3.17

TT Simulation Mode

You can simulate the risk of a collision by using the TT simulation mode. The test can
be terminated at any time by pressing the STBY/TX key.
1. Open the [MAIN MENU].
2. Select [INTIAL SETTING], then push the ADJUST knob.
3. Select [TEST], then push the ADJUST knob.
4. Select [TT TEST], then push the ADJUST knob.
The normal operation is suspended then three simulated targets appear on the dis-
play.
The indication "S" appears at the bottom of the effective display area during the sim-
ulation mode. The simulation may be terminated any time by going to the STBY mode.
Three simulated targets move as the following table. The simulated target is automat-
ically generated with the relative movement in the following table based on own ship's
movement at the start of simulation mode.
Note: If own ship moves after the start of simulation mode, the movement of the sim-
ulated target is not matched with the values in the following table.
Target 01
Target 02
Target 03
Place the cursor on a target, then press the TGT ACQ key to display the target data.
Acquire the simulated targets after the TT simulation mode is performed. The tracking
state changes from unstable to stable and the vector appears. You can simulate the
movement of each function with changing true/relative vector, stabilization through the
water/over the ground, range or length of vector.
Repeat the check for all targets.
Range (R) Bearing (R)
9.5 NM 270.0°
1.1 NM 333.0°
9.3 NM 45.0°
01
Speed (R) Course (R)
20.0 kn 90.0°
10.2 kn 90.2°
19.9 kn 225.1°
03
02
S
3. TARGET TRACKING (TT)
CPA TCPA
0.0 NM 28.5 min
1.0 NM 2.9 min
0.0 NM 28.0 min
3-19