Type B Module Installation - Xycom XVME-976/202 Manual

XVME-976 Adapter Module
13. Align the PC/104 connectors of the XVME-976 with the corresponding
connectors on the Type A module.
14. Gently press the two boards together. Do not bend or twist the XVME-
976.
15. Fold the mylar shield down.
16. Install the remaining screws to secure the Type A module.
17. Align the three connected modules (with the Type A module on the
right) on the plastic guides in the slots leading to the VME backplane.
18. Gently push the modules to the rear of the chassis until the P1 and P2
connectors engage.
19. Tighten the screws on the front panel of the XVME processor module to
secure the connected modules into place. The installation is complete.

Type B Module Installation

The XVME-976 is configured to accept the installation of generic Type B
modules in the PC/104 site. Type B modules contain cable connectors may
require a Xycom front panel kit. Additional equipment included or required
for connecting a Type B module to the XVME-976:
•
Xycom front panel kit
•
Six standoffs
•
Two nylon screws (secures the module to the XVME-976)
•
Four nylon screws (secures the front panel to the XVME-976)
Type B modules purchased from Xycom will include a front
panel kit. PC/104 modules purchased from a third party will not
contain front panel kits compatible with the XVME-976.
1-8
Note